Industry News

  • Cylindrical bore bearing installation --- press into the press method

    Cylindrical bore bearing installation --- press into the press method

    Jan 2018,16

    Small bearings widely used presses press into the method. Shown in Figure 1, the block against the inner ring, with a press slowly pressed to the end face of the inner ring close to the shoulder. The ...

  • • How should the bearing avoid damage

    • How should the bearing avoid damage

    Jan 2018,10

    • In general, the proper use of bearings can achieve fatigue life. However, if an unexpected early injury occurs, it can not be used anymore. Unlike fatigue life, this early injury is called a failure...

  • Tapered bore bearing removal

    Tapered bore bearing removal

    Jan 2018,08

    Remove the smaller bearing with adapter sleeve, support the inner adapter with the stop fastened to the shaft, unscrew the nut, insert the spacer, and then hammer the bushing with a hammer. Pull the w...

  • Taper hole bearing installation

    Taper hole bearing installation

    Jan 2018,04

    Cone bearing directly to the inner ring fixed to the taper shaft or adapter sleeves, demount sleeves mounted to the cylinder shaft Large spherical roller bearings multi-purpose hydraulic installation,...

  • Hot work related matters needing attention

    Hot work related matters needing attention

    Jan 2018,03

    Bearing heating temperature to bearing size, the required amount of interference. Hot work related matters needing attention, as follows. • (a) Bearing heating must not exceed 120 ° C. • (b) To keep t...

  • Bearing cleaning

    Bearing cleaning

    Dec 2017,27

    When servicing and disassembling the bearings, first record the appearance of the bearings and check the remaining amount of lubricant. After sampling, clean the bearings. Cleaners commonly used gasol...

12345...>>